Weller PYROPEN Piezo Manuel D'utilisation page 16

HOW TO USE THE SOLDERING TIP
1.
Be sure the hot air exhaust opening is
positioned upward, as illustrated. Keep
hands and combustibles clear of exhaust
opening to avoid burns or fire.
3.
Push ignition button slowly and hold
three seconds after it clicks.
5.
Adjust tip temperatur with gas control
lever.
HOW TO USE THE HOT BLOW NOZZLE
1.
Loosen knurled nut to remove tip and tip
housing being careful not to cut piezo
wiring.
15
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
2.
Set control lever to "3". Set gas ON/OFF
lever to "ON" position. In cold tempera-
tures or immediately after gas filling set
lever higher than "3".
4.
Wait until the window becomes red, then
release button slowly. If it fails to ignite,
repeat ignition process outlined under
stip 3 above.
6.
To turn off, slide the gas ON/OFF lever to
"OFF" position until it clicks. (Control
lever does not turn off).
2.
Replace with hot blow nozzle. Ignition is
the same as for soldering.