Maintenance Guidelines - GEO plast GEOtank Mode D'emploi

Masquer les pouces Voir aussi pour GEOtank:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Návod na obsluhu / Manual / Mode d´emploi - GEOtank
7. Maintenance giudelines
Problems/ Defaults
1. Gear motor in cover unit
does not at all or just
temporary start
2. Blockage at the hand-
over- point in the
underground tank
3. Drawing clear is not
working
4. Tank ran undisturbed for
some time, but no pellets
are delivered to the heating
5. A foreign substance was
inserted into the already
filled tank and blocks the
screw in the bottom area
Possible Reasons
The motor does not activate the
heating correctly, the wiring is
wrongly connected
Blockage of the hand-over-
point in the Underground tank
Motor protection is wrongly
connected
A foreign substance was
brought in either before or
during the filling of the tank and
blocks the screw at the bottom
area
The cyclone at the heating
does not seal properly
Air speed in the assisting hose
is too low
Too low or no pulsing at all
Gear motor ran without the
exhaust for some time and the
amount of pellets at the hand-
over-point is too high
The tank is empty
Underground tank is nearly
empty (the surface of the cone
in the underground tank can
use delusion)
E.g. a metallic foreign
substance as such as a
screw,... fell into the already
filled tank during installation
V00070130
Disposal
 Read the maintenance guidelines
 Connect the wiring of the motor
correctly see point 9 motor wiring
 see point 2 blockage
 Connect motor protection
correctly
( consider motor data )
 see point 8 foreign substance in
the tank
 Clear timing device at the cyclone
from dust and pellets remains
 Check hoses and reattachments
(loose hose clamps,...)
 Check cyclone
 Pulsing of the holding motor ( ratio
of running time of the motor towards
the fan) must be adapted to the
particular length of the hose and the
boiler control
 Draw clear afterwards see point 6
 Lifting the screw see section 7
 needs new filling
 needs new filling
 foreign substance in the tank see
point 8
53

Publicité

Chapitres

Table des Matières
loading

Table des Matières