Návod na obsluhu / Manual / Mode d´emploi - GEOtank
4.10 Liquid level indicator
The liquid level indicator is used to record the amount of pellets in the earth tank.
The liquid level indicator measures the time of the holding motor and calculates the pellets amount taken. The electric
signals are detected and confered to the liquid level indicator.
Control lamp
Lights up if the
gear motor is
running
2. Filling button
At a complete filling of the tank the filling button must be pressed about 10 sec. (until all filling lamps light up) – via this,
the control of the container will be set on full again.
At a partial filling, the filling button must be pressed as long as the requested filling lamp lights up. With this operation,
the control will position itself on full after about 10 sec. If the filling button will be pressed further, the control turns itself
back with one filling lamp at the time.
At GEOtank 8000: every filling lamp meets 650kg
At GEOtank 11000: every filling lamp 1000kg
i.e.: GEOtank 11000 will be filled with 3000kg three filling lamps more must light than before
Because there are different qualities of pellets, for that reason some abnormalities of taken pellets from the measured
amount of pellets can occur. Therefore, the quantity stored should be checked before the indicated deflation.
3. Schematic diagram
1
2
3
4
5
L
N
Heizungs=
steuerung
L
N
6
7
8
Filling lamps
Filling button
S
Security advice
•
The mounting may only be accomplished by an
officially franchised company
•
To any danger, the health and safety regulations
must be followed
•
The in the guidelines described point must be
followed!
•
At any kind of non-observance, the warranty will
expire.
5. Possible cause of defect
•
control lamp lights up constantly
wiring is wrongly connected
M
V00070130
49