Using The Geom (Geometry) On-Screen Display - Sony Trinitron CPD-520GST Mode D'emploi

Using the GEOM (Geometry) On-
screen Display
The GEOM (geometry) settings allow you to adjust the
shape and orientation of the picture.
Once the rotation is adjusted, it will be stored in memory for
all input signals received. All other adjustments will be
stored in memory for the current input signal.
1
Press the MENU button.
The MENU OSD appears.
MENU
2 Press the ¨./> and >?// buttons to select "
GEOM," and press the MENU button again.
The GEOMETRY OSD appears.
3 Press the ¨./> buttons to select the item you want
to adjust.
Select To
ROTATION adjust the picture rotation
PINCUSHION adjust the picture sides
PIN BALANCE adjust the picture side balance
KEYSTONE adjust the picture width
KEY BALANCE adjust the picture shape balance
4
For
GEOMETRY
26
ROTATION
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on.
The selected item is reset to the factory setting.
Getting Started
Customizing Your Monitor
Press the >?// buttons to adjust the settings.
Press
ROTATION / . . . to rotate the picture clockwise
? . . . to rotate the picture counterclockwise
PINCUSHION / . . . to expand the picture sides
? . . . to contract the picture sides
/ . . . to move the picture sides to the right
PIN BALANCE
? . . . to move the picture sides to the left
/ . . . to increase the picture width at the
KEYSTONE
top
? . . . to decrease the picture width at the
top
KEY BALANCE
/ . . . to move the top of the picture to
the right
? . . . to move the top of the picture to
the left
EN
F
ES
C
11