Symbols On The Charger - Black & Decker PSA115B Mode D'emploi

Symbols on the charger

Read all of this manual carefully
before using the appliance.
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to
the voltage on the rating plate.
$
The charging base is intended
for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code:
Only use with charger N494249
N494249
Features
This tool includes some or all of the following features.
1. On/off power button
2. Sweeper head
3. Handle
3 a. Hole for storage
4. Middle poles (x2)
5. Lower pole
6. Sweeper head pole
7. Dustbin
8. Dustbin release tabs
9. Cleaning tool
1 0. Charging dok
11. Storage magnet
Assembly (Fig. A)
Slide the lower pole ( 5 ) into the sweeper head pole ( 6 ).
u
Ensure the slot of the lower pole is on the top.
Slide one of the middle poles ( 4 ) into the lower pole.
u
Ensure the nub of the middle pole lines up with the slot of
the lower pole.
Slide the second middle pole into the first. Ensure the nub
u
of the second middle pole lines up with the slot of the first
middle pole.
Slide the handle ( 3 ) into the second middle pole ( 4 ).
u
Ensure the nub of the handle lines up with the slot of the
middle pole.
Charging the battery (Fig. B)
The battery will need to be charged for a minimum of 10
u
hours before first use to ensure full power.
(Original instructions)
Plug the jack plug of the charger ( 12 ) into the charging
u
dock ( 10 ) of the tool as shown in Figure B. Plug the
charger into a power outlet. The charging indicator will
be lit. While charging, the charger may get warm, this is
perfectly normal and safe. It is safe to leave the appli-
ance connected to the charger indefinitely. The charger
automatically reduces power consumption when charging
is complete.
When charging is complete, the LED will turn off.
u
Use
Switching on and off (Fig. C
To switch the appliance on, press and hold the on/off
u
switch (1) with your foot.
To switch the appliance off, depress the button again.
u
Emptying and cleaning the product (Fig. D
Hold the sweeper over a garbage can.
u
Simultaneously press both dust bin release tabs ( 8 ). The
u
door of the dust bin ( 7 ) underneath the sweeper head
( 2 ) will drop open, releasing the dust and dirt.
Close the dust bin door until the two release tabs click
u
into place.
Cleaning beater bars Fig. E
Turn the sweeper upside-down to expose the beater
u
brushes.
Use the comb side ( 13 ) of the cleaning tool ( 9 ) to pull
u
away any hair or debris.
If needed, use the blade side ( 14 ) of the cleaning tool to
u
cut away hair or debris for easier removal.
Note: Ensure all hair is removed from the areas shown in
figure E1.
Storage
Warning! Store the sweeper so that if the handle falls, it will
not strike a person, animal, or valuable.
To store, lift the back of the sweeper head ( 2 ) up until
u
the storage magnet ( 11 ) engages with the metal plate.
Place the plastic caps of the cleaning tool on either end
u
and snap the tool onto a pole.
The sweeper has a hole (3a) situated on the handle (3)
u
which is ideal for hanging the unit from a wall fitting.
Note: Always empty the unit before storing.
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
ENGLISH
)
)
5