Preparing The Card Remote Commander; Attaching The Front Panel; Detaching The Front Panel - Sony MEX-DV2000 Mode D'emploi

4
Rotate the volume control dial to
select your listening position, then
press it.
Select "FRONT L" if your listening position
is front left, or select "FRONT R" if front
right.
The clock display appears when the setting is
complete.
This setting can then be further configured in
setup or the sound menu.
For details on setting the speaker connection
status, see "Speaker configuration and volume
setup" on page 38. For details on setting the
listening position, see "Optimizing sound for the
listening position — Intelligent Time
Alignment" on page 35.
Note
If you set to "C ON" without connecting the center
speaker, vocal sound is not output, and if you set to
"SW ON" without connecting the subwoofer, bass
sound is not output.
With the card remote commander
Press M/m instead of rotating the volume control dial,
press (ENTER) instead of pressing the volume control
dial.
Preparing the card remote
commander
Before using the card remote commander for the
first time, remove the insulation film.

Detaching the front panel

SOURCE
You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1
Press (OPEN) while the unit is off.
The front panel is flipped down.
2
Slide the front panel to the right, then
gently pull out the left end of the front
panel.
Notes
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.

Attaching the front panel

Place the hole A of the front panel onto the
spindle B on the unit, then lightly push the left
side in.
Press (SOURCE) on the main unit (or insert a
disc) to operate the unit.
OPEN
Note
Do not put anything on the inner surface of the front
panel.
1
2
A
B
c
13