Front Panel; Rear Panel - IMG STAGELINE DMP-130MIX Mode D'emploi

All operating elements and connections de -
GB
scribed can be found on the fold-out page 3.
1 Operating Elements
and Connections

1.1 Front panel

1 Button USB / SD to switch between USB stor-
age medium and SD / MMC card
2 Slot to insert an SD / MMC memory card
(32 GB max.)
3 USB interface to connect a USB flash drive or
a hard disk with separate power supply
4 POWER switch
5 Input MIC to connect a microphone;
combined XLR / 6.3 mm jack, bal.
6 Input AUX to connect a unit with line output
(e. g. CD player, radio); 3.5 mm jack, stereo
If you use this jack, the integrated MP3 player
will be muted.
7 Display of the MP3 player
Details see fig. 2
a indication of the signal source selected:
S = SD / MMC card
U = USB storage medium
b indication of title number or number of titles
if the button I (9) was pressed
c title name
d indication "Play", "Pause" and "Stop"
e indication alternating between the time
already played of a title and the playing
time of the title
f indication "All" (all titles are replayed re -
peatedly) or "One" (continuous repeat of
the current title); switchable with the button
REPEAT (8)
8 Button REPEAT to switch between
Repeat of all titles:
indication "All" (f)
Repeat of the current title
indication "One"
9 Button I to stop the replay
10 Button to start the replay and to switch
between replay and pause
11 Button and for title selection and for
fast forward / reverse
Title selection
To go to the next or previous title, simply
press the button.
Fast forward / reverse
For fast forward, keep the button
pressed; for fast reverse, keep the button
pressed.
12 Button EQ to select various sound adjust-
ments for the MP3 player
Field (d) of the display briefly shows the adjust-
ment selected.
13 Input level control MIC for the signal of a
microphone connected to the jack MIC (5)
14 Level control AUX / MP3 for the MP3 player or
for the signal of a unit connected to the jack
AUX (6)
15 Input level control LINE for the signal of a unit
connected to the jacks INPUT (18)
16 Level control for the sum signal at the outputs
(19 and 20)
17 Tone controls for the sum signal
6

1.2 Rear panel

18 RCA jacks INPUT to connect a unit with line
output (CD player, radio, tape deck, etc.)
19 RCA jacks OUTPUT for the output of the sum
signal
20 XLR connectors (chassis plugs) OUTPUT as
an additional balanced output for the sum
signal
21 Mains jack for connection to a socket (230 V~/
50 Hz) via the mains cable provided
22 Support for the mains fuse
Only replace a blown fuse by one of the same
type.
2 Safety Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING
The unit uses dangerous mains
voltage. Leave servicing to skilled
personnel only. Inexpert handling
may result in electric shock.
Please observe the following items in any case:
G
The unit is suitable for indoor use only. Protect
it against dripping water and splash water,
high air humidity and heat (admissible ambi-
ent temperature range: 0 – 40 °C).
G
Do not place any vessel filled with liquid on the
unit, e. g. a drinking glass.
G
Do not operate the unit and immediately dis-
connect the mains plug from the socket
1. if the unit or the mains cable is visibly dam-
aged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by
skilled personnel.
G
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug.
G
For cleaning only use a dry, soft cloth; never
use water or chemicals.
G
No guarantee claims for the unit and no liabil-
ity for any resulting personal damage or mate-
rial damage will be accepted if the unit is used
for other purposes than originally intended, if it
is not correctly connected or operated, or if it
is not repaired in an expert way.
G
Important for U. K. Customers!
The wires in this mains lead are coloured in
ac cord ance with the following code:
green/ yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. The wire which is coloured green and yel-
low must be connected to the terminal in the
plug which is marked with the letter E or by
the earth symbol , or coloured green or
green and yellow.
2. The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
3. The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
Warning – This appliance must be earthed.
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment.
3 Applications and Setup
The DMP-130MIX with three input channels and
integrated MP3 player is designed for mixing
various audio signal sources to a stereo sum:
– channel MIC for a microphone
.
– channel AUX / MP3 for the integrated MP3
player or a unit with line output (CD player,
radio, tape deck, etc.)
– channel LINE for a unit with line output
The unit is designed for installation into a rack
(482 mm / 19"), but it can also be used as a stand-
alone tabletop unit. For rack installation, one RS
(rack space = 44.45 mm) is required.
4 Setting Up and
Connecting the Unit
Prior to making or changing any connections,
switch off the DMP-130MIX and the units to be
connected.
1) The jack MIC (5) is used to connect a micro-
phone with XLR plug or 6.3 mm plug.
2) The RCA jacks INPUT (18) are used to con-
nect a stereo unit with line output (CD player,
radio, tape deck, etc.).
If the integrated MP3 player is not used, it
is possible to connect another stereo unit with
line output to the 3.5 mm jack AUX (6). If you
use the jack, the MP3 player will be muted.
3) To route the sum signal, e. g. to an amplifier,
two outputs are available which can be used
at the same time:
the RCA jacks OUTPUT (19) and
the XLR connectors OUTPUT (20)
Due to a higher sensitivity to interference, a
balanced connection via the XLR outputs is
preferable to the RCA outputs.
4) First connect the mains cable provided to the
mains jack (21); then connect it to a mains
socket (230 V~ / 50 Hz).
5 Operation
Switch on the unit with the POWER switch (4).
The display (7) shows "No Disk Please Add
Disk". If a memory card or USB flash drive has
been inserted or a hard disk has been connected
and this medium has been loaded, the display
will show the number of titles: "Total Song: U*...".
* U = USB storage medium is selected
S = memory card is selected
The second line shows the message "Please
Enter Key". To start the replay, press the button
(10).