IMG STAGELINE DMP-130MIX Mode D'emploi page 7

5.1 Mixing the audio signals
1) Set the controls MIC (13), AUX / MP3 (14) and
LINE (15) of the input channels not used to
MIN. For the time being, set the other con-
trols to mid-position.
2) Feed an audio signal to each of the input
channels and set the output level with the
control VOLUME (16) in such a way that the
successive unit is controlled to an optimum
level.
3) Adjust the sound of the output signal with the
controls TREBLE and BASS (17).
4) Use the controls MIC, AUX / MP3 and LINE to
mix the audio signals or to fade them in and
out. If necessary, adjust the output level with
the control VOLUME.
5.2 MP3 player
Do not connect a plug to the jack AUX (6), oth-
erwise the MP3 player will be muted.
1) Connect a USB flash drive or a hard disk* to
the USB port (3)
* The hard disk must have one partition only and
must be supplied with power via a separate power
supply unit.
and / or
insert an SD / MMC memory card into the slot
SD (2), the notched corner to the right and
facing the unit. To remove the card, slightly
push it in to eject it from the slot.
2) Press the button (10) to start the first title.
The display shows "Play" (d). The field (e)
next to it alternately shows the time already
played of the title and the playing time of the
title.
3) To switch between USB storage medium and
memory card, press the button USB / SD (1).
Field (a) of the display shows the storage
medium selected:
U = USB storage medium
S = SD card
4) To go to the next or previous title, briefly
press the button or
shows the title number on the top left (b) and
next to it in the field (c) the title name if it is
stored as an ID3 tag in the audio file.
5) For fast forward, keep the button
for fast reverse, keep the button
Fast forward / reverse is only possible within a
All rights reserved by MONACOR
manual may be reproduced in any form or by any means for any commercial use.
title. You will not be able to trace it acousti-
cally, only via the time indication (e) on the
display.
6) To switch between replay [indication "Play"
(d)] and pause [indication "Pause"], press the
button
7) To switch between repeat of all titles [indica-
tion "All" (f)] and continuous repeat of the cur-
rent title [indication "One"], press the button
REPEAT (8).
8) The button EQ (12) is used to select various
sound adjustments for the MP3 player. The
adjustment selected is briefly shown in field
(d) of the display.
9) To stop the replay, press the button I (9).
The display shows "Stop" at the bottom on
the left (d) and the number of titles above it
(b).
6 Specifications
Frequency response: . . . . 20 – 20 000 Hz
THD: . . . . . . . . . . . . . . . . < 0.1 %
Channel separation: . . . . > 60 dB
Dynamic range: . . . . . . . . > 96 dB
S / N ratio: . . . . . . . . . . . . . > 70 dB
Inputs
Sensitivity / impedance; connection
MIC: . . . . . . . . . . . . . . . 2.5 mV / 500 Ω;
AUX: . . . . . . . . . . . . . . 350 mV / 7.5 kΩ;
LINE: . . . . . . . . . . . . . . 850 mV / 20 kΩ; RCA
Output level
XLR, bal.: . . . . . . . . . . . 2 V
RCA: . . . . . . . . . . . . . . 1 V
Power supply: . . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . . 20 VA max.
Ambient temperature: . . . 0 – 40 °C
Dimensions (W × H × D): . 482 × 44 × 160 mm,
(11). The display
Weight: . . . . . . . . . . . . . . 2.2 kg
pressed;
pressed.
Subject to technical modification.
® INTERNATIONAL GmbH & Co. KG. No part of this instruction
.
XLR and
6.3 mm jack, bal.
3.5 mm jack, stereo
1 RS (rack space)
7