Commissioning - IKA VC 10 Mode D'emploi

Speed control
MVP 10 digital vacuum pump with IKA
Automatic adjustment of the "analog speed control" mode if the
analogue connection cable (Pos. 8) is connected to the pump with
the vacuum controller.
Once the target value is reached the pump speed is automati
Illustration speed control - vacuum pump IKA
Check whether the voltage given on the type plate corresponds to
the available mains voltage.
If these conditions have been met, the machine is ready for opera-
tion when the mains plug is plugged in.
Start screen layout at the time of delivery
The start screen appears for a few
NOTICE
seconds when the device is swit-
ched using the "Standby ON/OFF"
switch (F) The device name and the
software/firmware
also displayed.
36
® VC 10 vacuum controller
MVP 10 digital with vacuum controller IKA
®

Commissioning

The socket used must be earthed (fit-
ted with earth contact).
versions
cally reduced to a minimum "0 rpm". Once the target value is
reached, the pump operates according to the leakage rate of the
vacuum system.
Automatic boiling point recognition is possible.
If these conditions are not met, safe operation is not guaranteed
and the machine could be damaged.
Also pay attention to the ambient conditions listed in the "Tech-
nical data".
An information prompt then appears to download the IKA
ware update tool.
are
VC 10
®
firm-
®