Basic Operation - AudioSonic CL-480 Mode D'emploi

connectIons
antenna connection
• The clock radio comes with an FM wire antenna at the rear; please extend for
best reception.
power source
• The unit is powered by 230V~50Hz mains power supply. The 3V Lithium button
cell CR2032 (not supplied) is used for clock back-up only. Please remove the
battery during long period of non-use to avoid battery leakage.
• To avoid damages not covered by the warranty only connect the unit to above
power supply.
Insert/change Back-up Battery
• Insert the back-up battery in the battery compartment at the bottom of the
unit; you need a Phillips screwdriver to open the battery compartment. Please
observe the polarity.
• Change the back-up battery once a year.
• Your settings (alarm, current time, etc.) are retained during power failure or when
temporarily disconnecting from mains power supply; the unit automatically
switches to back-up battery.

BasIc operatIon

turn clock radio on/off
• Turn the radio off with the on/off , when not in use. Turn volume min/max to
adjust the volume. Select the frequency band with the band selector band am/
fm, toggle between FM and MW.
• After use, please turn the unit off. To save energy, please disconnect the unit
from mains power supply and remove the battery to avoid battery leakage when
not in use for a long period of time.
• The display either shows the current time or the frequency of the radio station.
• The unit is designed for continuous operation; it is either in ON mode or in
standby mode.
6
Instruction Manual
display Brightness
• You can set the brightness of the display with the toggle switch dimmer low/
high at the rear of the unit. Set to low for dim backlight, set to high for a brighter
display.
set current time
• When first connecting the unit 0:00 is displayed.
• Press and hold the time button and simultaneously press hour to set the hours
in 24-hour mode. Press and hold the button for fast setting or tap it briefly to
increase the setting by one hour.
• Now set the minutes with time (press and hold) and min.
• Press and hold the button for fast setting or tap it briefly to increase the setting
by one minute. The current time is set.
radio
• Press on/off to turn the radio on. The display shows the frequency band (MW
or FM) and the frequency (e.g. 100.6 MHz and 525 KHz). Select the frequency
band with the band selector band am/fm, toggle between FM and MW. With
tuning you tune into your favourite station, the frequency is displayed in large
digits on the display.
• Turn volume min/max to adjust the volume.
• Press on/off to turn the radio off.
• The radio comes with an FM wire antenna; please unwind for best reception. For
best MW reception please direct the radio.
Line in Jack
• Connect your portable MP3 player or other audio devices via 3.5mm jack audio
cable (not supplied) to play back via your clock radio.
Wake to radio or Buzzer
• Select the desired radio station and volume level.
• Press and hold the alarm set button and simultaneously press the hour set
button to set the desired alarm hour. Press and hold the button for fast setting or
tap it briefly to increase the setting by one hour.