Troubleshooting Guide - Sartorius YDP10-0CE Mode D'emploi

Troubleshooting Guide

LED Cause
Red Data in printer memory
(EEPROM) defective
(checksum invalid)
Red The capacity of the
input buffer has been
exceeded
Red No control signal from
printer
Flashing red Low battery power
Batteries dead
Red Transmission error
in a data string
Solution
§ Press the P key
> Factory settings are loaded
$ It may be necessary to configure
menu settings for the printer port
and in the statistics application
§ Switch the weighing instrument
off and then on again
§ Press the P key
§ Press the P key
§ Check the batteries
$ Recharge batteries if necessary
$ Replace the batteries if necessary
§ Recharge batteries (see
"Maintenance")
§ Make sure the interface parameter
settings in the printer match those in
the weighing instrument
§ Press the P key
9