Operation; Printing A Measured Value From The Connected Weighing Instrument; Configuration - Sartorius YDP10-0CE Mode D'emploi

123456789012345678901234
001: + 123.4
8

Operation

The data printer has 2 function keys for
operation:
P
: Line feed; advances the paper by one blank line.
P
: Print measured value or begin automatic
printing
Printing a Measured Value from the Connected
Weighing Instrument
$
Advance paper to desired position, if necessary:
Press the G key (repeatedly if desired), or press
and hold for continuous line feed
§
To print data, press the P key
g
> A sample printout is shown here on the left

Configuration

Configuring the Operating Menu
Note:
The connected weighing instrument must be
configured for data communication with the
printer.
Configuring the Weighing Instrument's Printer
Port
The following settings are configured in the
printer at the factory:
9600 baud, 8 bits, odd parity, one stop bit, hard-
ware handshake (CTS/DTR)
When the printer is turned on, these settings are
loaded in the printer's memory (EEPROM) for use
during operation.