WAGNER AG-08 Manuel D'utilisateur page 6

Cleanup
Maintaining a clean gun is important to ensure trouble-
free operation. Flush the gun after each use and store
in a dry location. Do not leave the gun or any of its
parts in water or solvents.
WARNING
Special cleanup instructions for use with flammable
solvents:
• Always flush spray gun preferably outside and at
least one hose length from spray pump.
• If collecting flushed solvents in a one gallon metal
container, place it into an empty five gallon
container, then flush solvents.
• Area must be free of flammable vapors.
• Follow all cleanup instructions.
CAUTION
The sprayer, hose, and gun should be cleaned
thoroughly after daily use. Failure to do so permits
material to cake, seriously affecting the
performance of the unit.
WARNING
Always spray at minimum
pressure with the tip and tip guard
removed when using mineral
spirits or any other solvent to
clean the sprayer, hose, or gun.
Static electricity buildup may
result in a fire or explosion in the
presence of flammable vapors. Hold the gun firmly
against a metal container while flushing.
R
GB
Maintenance
Follow all safety precautions as described in the
Safety Precautions section of this manual before
proceeding.
NOTE: Refer to the Parts List section in this
manual for part identification.
Replacing/Servicing the Seal
Assembly
If your spray gun leaks or spits at the tip when you
release the trigger, the needle or seat is worn,
damaged, or dirty and must be replaced or cleaned.
Never attempt to perform maintenance on the spray
gun without first performing the "Pressure Relief
Procedure."
1. Disconnect the fluid hose from the gun.
2. Remove the tip and tip guard.
3. With the trigger depressed, remove the diffuser
from the front of the gun.
4. Remove the lock nut, rear housing, and retractor
pins from the rear of the gun head.
5. Remove the seal assembly from the front of the
gun head by pushing or gently tapping at the back
of the seal assembly.
6. Soak the removed parts in the appropriate solvent
and wipe clean.
7. Inspect the parts for wear or damage and use new
parts during reassembly of the gun, when necessary.
6
WARNING
WARNING
© Wagner. All rights reserved.