Sony T FUTURE LAB FL-101 Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
Notes on wireless LAN
Sony is not liable for any loss or damage caused by loss or
theft of the unit resulting in unauthorized accesses to or
abuse of the equipment which is incorporated into the unit.
Notes on wireless LAN security
• Always make sure that you are using a wireless LAN that is
secured against hacking, access from malicious third
parties, and other vulnerabilities.
• Proper security setting for a wireless LAN is very important.
• Sony is not liable for any loss or damage caused by security
problems resulted from failing to take security
countermeasures, or unavoidable circumstances due to
specifications of the wireless LAN.
If you have questions or problems, read this document
thoroughly again, and visit the dedicated web site for more
information. If the answer is not found, consult qualified Sony
personnel.
Specifications
Projector
Display system:
Projection system
Display device:
0.37 inch SXRD × 1,
1366 × 768 pixels
Projection image size:
32 inches to 40 inches (can be
changed by adjusting the height of the
stand)
Light source:
Laser diode
Light output:
200 lm (Typ.)
Storage
Internal storage:
SSD 32 GB
Interface
Touch operation:
Up to 8 fingers
RGB camera:
8 M pixel for still image,
2 M pixel for movie
Microphone:
8 monaural microphones
Audio
Speakers:
Approx. 32 mm diameter × 1
(monaural)
Amplifier*:
3 W monaural (total harmonic
distortion 10%, 1 kHz, 4 ohms)
* You can set Clear Phase™ according to the scene.
– Clear Phase Enable: Flat sound setting for various scenes
– Clear Phase Disable: Dynamic sound setting for Demo Scene
Network communication
Ethernet:
1000 Base-TX
Wireless LAN:
IEEE 802.11a/b/g/n/ac (2.4 GHz band,
5 GHz band)
General
Operating temperature:
5 °C to 35 °C
Dimensions:
Approx. 300 mm × 107 mm × 111 mm
(width × height × depth)
Mass:
Approx. 2.2 kg
Supplied accessories:
AC adaptor (1)
Power cord (mains lead) (1)
Operating Instructions (this document)
(1)
Optional accessories:
Table stand FL-T01STD01 (including
M3 × 10 screw (4), M4 × 8 screw (2),
VESA mounting bracket (1))
Design and specifications are subject to change without
notice.
9
GB

Publicité

Table des Matières
loading

Table des Matières