Gardena EasyCut Li-18/23 R Mode D'emploi page 8

z
u
ö
Setting the trimmer to body
height:
h
o
1
t
Adjusting the plant guard:
Starting the trimmer:
p
a
20
Working position 3 (only for art. 9825):
The upright must be in the uppermost position in working
position 3.
1. Turn the plant guard
locks into place.
2. Press the foot pedal
uppermost position.
z
3. Press the button
until it engages.
4. With the impeller, move the trimmer along the lawn edge.
CAUTION! The trimmer may only be used provided that the
trimmer head is engaged at an angle of 0° or 90°.
Setting the shaft length:
v Loosen the clamping sleeve
desired shaft length and re-tighten the threaded collar
t
The clamping sleeve
prevent the shaft from being moved.
Setting the additional handle:
o
v Pull the lock belonging to the additional handle
set the additional handle
o
release the lock .
If the trimmer is correctly set to the body height, the posture
is upright and the trimmer head in working position 1 is tilted
forwards slightly.
v Hold the trimmer by the handle
such a manner that the trimmer head is tilted forwards slightly.
ö
Working position
ö
v Turn plant guard
until it locks into place.
Switching the trimmer on:
1. Press and hold the safety lock
a
button on the handle.
2. Release the safety lock
Switching the trimmer off:
v Release the start button
ö
by 90° to its parking position until it
u
and move the upright into the
and rotate the trimmer head from 0° to 90°
t
, extend the handle
must be fastened firmly enough to
h
to the desired incline and
1
and additional handle
ö
Parking position
through 90° into the required position
p
and then press the start
p
again.
a
on the handle.
1
to the
t
.
h
,
h
in