I-Tech MAG1000 Manuel D'utilisation page 25

Masquer les pouces Voir aussi pour MAG1000:
Table des Matières

Publicité

Guidance and manufacturer's declaration – ELECTROMAGNETIC IMMUNITY –
MAG1000 is intended for use in the electromagnetic environment specified below.
The user or operator of MAG1000 should assure that is used in such environment.
Immunity test
Mains power
electromagnetic
field
IEC 61000-4-8
Note: U
is the AC mains voltage before the application of the Test level.
T
Guidance and manufacturer's declaration – ELECTROMAGNETIC IMMUNITY FOR
DEVICES AND SYSTEMS THAT ARE NOT OF VIABLE FUNCTION
The MAG1000 device is expected to operate in the electromagnetic environment
below specified. The user or operator of the MAG1000 device must ensure that it
is used in this environment.
Immunity test
Portable and mobile RF communications equipment should not be used near any
part of the MAG1000 device, including cables, except where recommended
separation distances are observed, calculated from the equation applicable to
frequency of the transmitter.
Conducted RF
IEC 61000-4-6
Irradiated RF
IEC 61000-4-3
where (P) is the maximum output power rating of the transmitter in Watts (W) according to the
transmitter manufacturer and (d) is the recommended separation distance in meters (m).
Field strengths from fixed RF transmitters, as determined by an electromagnetic site survey
should be less than the compliance level in each frequency range
Interference may occur in the vicinity of equipment marked with the following
symbol:
Note:
(1)
At 80 MHz and 800 MHz the separation distance for the higher frequency range
applies.
IACER Srl
FOR ALL DEVICES AND SYSTEMS
Test level
IEC 60601
3 A/m
Test level
Compliance
IEC 60601-1-2
3V
from
3V
eff
eff
150kHz
to
150kHz
80MHz
80MHz
3V
from
3V
eff
eff
80MHz
to
80MHz
2,5GHz
2,5GHz
Compliance
level
Mains power quality
should be at least that
3 A/m
one
commercial
hospital environment.
Electromagnetic
level
environment – guidance
Recommended separation distance
from
Recommended
to
distance:
d = 1,2 ⋅√P 150kHz to 80MHz
d = 1,2 ⋅√P 80 MHz to 800
from
MHz
to
d = 2,3 ⋅√P 800 MHz to 2,5
GHz
.
b
25
Electromagnetic
environment –
guidance
of
a
typical
or
separation
,
a
MNPG251-03

Publicité

Table des Matières
loading

Table des Matières