Installing A Hi-Speed Usb 2.0 Hub - Belkin F5U508 Manuel De L'utilisateur

P73954ec-A-F5U508-man.qxd 22-11-2002 15:41 Page 21
Note: During installation of a Belkin Hi-Speed USB 2.0 PCI Card
driver, a Hi-Speed USB 2.0 Hub driver is also installed. When
you attach a Hi-Speed USB 2.0 Hub to your PCI Card
for the first time, follow the procedure described below.
1. Turn on your computer.
2. Plug the power adapter (ships with the hub) into the hub
and into a wall outlet.
3. Connect the flat end of the USB cable supplied with the hub
to your computer and the square end of the cable to the
upstream port of the hub.
4. Windows will automatically detect the hub and start the
"Add New Hardware Wizard". The wizard will search for
drivers for a "Generic USB Hub on USB 2.0 Bus".
Click "Next".
(If the search results list drivers for a "Generic USB Hub"
instead, cancel the wizard, go back to Device Manager and
confirm that the Belkin 2.0 drivers have been properly installed.)
5. Choose, "Search for the best driver for your device
(Recommended)". Click "Next" to continue.
6. Windows will now search the driver database on your
hard drive. Remove the check mark from all boxes and
click "Next".
7. Windows will locate the driver for "Generic USB Hub on
USB 2.0 Bus". Click "Next".
8. Click "Finish". Installation of your hub is now complete.

Installing a Hi-Speed USB 2.0 Hub

21
En