Belkin F5U508 Manuel De L'utilisateur page 20

P73954ec-A-F5U508-man.qxd 22-11-2002 15:41 Page 16
With Internet Connection
1. Make sure your computer is completely powered down.
2. Remove the computer's cover and locate an empty PCI slot.
3. Remove the port cover that corresponds with the PCI slot
you wish to use. (The cover is usually held in place with a
single screw.)
4. Insert the PCI Card into the slot. Apply pressure as needed
until the card is fully seated. Secure the PCI card with the
screw removed in step #3, above.
5. After installing the PCI Card, replace the outer cover and
turn on the computer.
6. When Windows restarts the PCI card will be detected and
drivers for the IEEE 1394 host controller, and the two USB
OHCI host controllers will be automatically installed.
Note: Depending on the speed of your computer, it may take
up to 45 seconds for the PCI card to be detected, and the
download from Windows update to be completed.
7. Windows will now search for drivers for the "NEC PCI to
USB Enhanced Host Controller B1", and the "New
Hardware Wizard" will start. Select "Install the software
automatically (Recommended)". Click "Next". Windows XP
will check the Windows update website and download the
most recent version of Microsoft's USB 2.0 support drivers.
Installation (continued)
16