Belkin F5U508 Manuel De L'utilisateur page 13

P73954ec-A-F5U508-man.qxd 22-11-2002 15:41 Page 9
select "No, I will restart my computer later". Select "Close".
Then select "Exit".
3. Open the Start menu in the lower left-hand corner of your
Windows display, then select "Shut Down" and click "OK".
4. Once the computer has completely shut down, remove the
computer's cover and locate an empty PCI slot.
5. Remove the port cover that corresponds with the PCI slot
you wish to use. (The cover is usually held in place with a
single screw).
6. Insert the PCI Card into the slot. Apply pressure as needed
until the card is fully seated. Secure the PCI card with the
screw removed in step #5, above.
7. After installing the PCI Card, replace the outer cover and
turn on the computer.
8. When Windows restarts the PCI card will be detected and
all required drivers will be automatically installed. After the
install is complete, you may be prompted to click finish and
to restart.
Note: Depending on the speed of your computer, it may take
up to 30 seconds for the PCI card to be detected.
Verifying Proper Installation (Windows 2000)
After installation is complete, check the Windows Device
Manager to confirm that all components of the PCI Card have
been properly installed.
Installation (continued)
9
En