Making A Disc Copy - Disc Dubbing; Making A Disc Copy - Sony HANDYCAM DCR-DVD100E Mode D'emploi

Making a disc copy – Disc Dubbing

Making a disc copy

You can make a copy of a finalised disc.
1
Turn on your computer and allow
Windows to load.
2
Connect the AC adaptor to your
camcorder.
3
Set the mode dial to
4
Turn the power on your camcorder by
sliding the POWER switch upward
while pressing the green button.
5
Insert a recorded disc into your
camcorder.
6
Connect the
camcorder and the
computer using the USB cable supplied
with your camcorder.
USB jack
7
Start the ImageMixer software on your
computer.
8
Click on the left of the screen.
9
Click
The confirmation screen appears.
100
-GB
(Play/Edit).
(USB) jacks of the
(USB) port of the
USB port
USB cable
(Duplication).
10
Click [OK].
11
When the copy completion message
appears, eject the disc and insert a new
disc into your camcorder.
12
Click [OK].
Copying of data from your computer to
the new disc starts. When the disc copy
operation is completed, a screen asking
if you want to make an additional copy
appears.
13
If you want to make an additional copy,
click [OK].
The making of an additional copy starts.
If you do not want to make an
additional copy, click [Cancel] to end
the procedure.
14
Eject the disc following the instructions
given in the on-screen messages.
Notes
•It may take some time to save the scene
depending on the recording mode (page 33)
and the length of the movie.
•You cannot make a copy of an unfinalised
disc.
•You cannot copy a DVD-RW recorded in VR
mode to a DVD-R. Use another DVD-RW.
•Using DVD-RWs for the copied media
prevents you from unfinalising and making
additional recordings on your camcorder
because the format of copied media is
different from that of your camcorder. You
must format the DVD-RW to record
additional material on the disc.
Tip
To use the disc with other DVD authoring
applications, an export procedure is required.
For details, see the ImageMixer on-line help.