Interfacing; Introduction; C 520 L - AKG MicroMic C520 Mode D'emploi

The C 520 /C 520 L is a condenser microphone
and therefore needs a power supply.
Using any power supply other than those rec-
ommended by AKG may damage your micro-
phone and will void the warranty.
1. Connect the phantom power adapter on the
microphone cable to a balanced XLR micro-
phone input with phantom power.
2. Switch the phantom power on. (Refer to the
instruction manual of the unit to which you
connected your C 420.)
1. Plug the mini XLR connector on the micro-
phone cable all the way into one of the two mini
XLR sockets on the B 29, the mini XLR socket
on the connecting cable of the MPA II, or the
input socket on the bodypack transmitter.
The connector will lock automatically.
• To disconnect the cable, press the unlocking
button on the mini XLR connector and pull the
connector out of the socket.
• T T o o a a v v o o i i d d d d a a m m a a g g i i n n g g t t h h e e c c a a b b l l e e , , n n e e v v e e r r p p u u l l l l a a t t
t t h h e e c c a a b b l l e e i i t t s s e e l l f f ! !
2. B 29 L: Connect the B 29 L to the desired input.
MPA V L: Connect the MPA V L to a balanced
XLR microphone input with phantom power
and switch the phantom power on.
AKG C 520/C 520 L

2 Interfacing

2.1 Introduction

L
Important!
2.2 C 520

2.3 C 520 L

2.3.1 B 29 L or
MPA V L
Disconnecting
the cable:
L
Important!
15