Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING! It is strongly recommended to insert the plug into a single outlet exclu-
sively reserved to the device. We do not recommend the use of multiple sockets
(power strip), adopters and patch cords.
The cable must not be bent.
The table has been designed and built to operate in a closed and dry room. The ambient operating condition are:
Temperature: 5° ÷ 40° C
Humidity: 30% ÷ 95% without condensation.
If the environmental conditions are particularly critical it is advisable to provide the room with an adequate air condi-
tioning system to bring the humidity and temperature values within acceptable limits.
WARNING! The table was not designed to work in environments with explosive at-
mospheres, in the presence of fine dust or corrosive gases, in the presence of acids,
corrosive agents, salt; it is also not suitable for operation in the presence of ionizing
and non-ionizing radiation (X-rays, laser, microwaves, ultraviolet rays).
WARNING! Do not expose the table to an excessively humid environment. If the
table gets wet, remove the plug from the outlet and have it checked by an Authori-
zed Service Centre.
STORAGE! For the correct functioning of the electrical equipment the storage of the
table must be at a temperature between -25° C and +55° C, and only for short periods
not exceeding 24 hours, to +70°C.
The table has no special requirements for storage, provided that it takes place in
a closed and dry rooms; this condition should also be ensured during all phases of
transport.
3. ENVIRONMENTAL WORKING
CONDITIONS AND STORAGE
7
Publicité
Table des Matières
