Kratki PANTHER MERLOT Manuel D'utilisation Et D'installation page 55

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The first ew start-ups can contribute to smell which may persist even several hours after operation.
This is a phenomenon caused by paint burning. Pets and birds can react sensitively to secreted
fumes. To speed up the process of the paint burning, warm the stove for a few hours, setting the
maximum height of the flam. If, during the first fire, there is sediment on the inside of the glass
surface, remove it using a glass cleaner. The first ope ation of the gas stove must be carried out within
a well- ventilated area.
When heating using gas you may encounter staining walls and ceilings. It is caused by the convection
movement of air and thus dust particles contained therein. A partial solution to this problem is frequ-
ent ventilation of the room in which the gas stove operates. If the stove is installed in a new building,
you should wait at least 6 weeks before lighting it for the first time o remove construction moisture
from the walls, floor and eiling.
Operation
Freestanding gas stoves are controlled wirelessly with a remote control. The system, as standard, is
powered by four 1.5V batteries installed in the receiver. Short cyclical signals appear for about three
seconds when you try to ignite the gas stove and it is necessary to replace the batteries in the receiver.
A long beep means that the controller switch on the line between the receiver and the interrupter
block (option) is in position „O" or one of the wires connecting the receiver to the controller is not
connected properly. Set the switch to „I". If the control flame does not light, it is necessary to shut off
the gas supply shut-off valve and contact a service technician. If, within six hours, the device does not
receive a command from the user, a system of automatic gas control will reduce the main burner flame
to the minimum. In the case of continuous operation without user intervention for fi e days after the
last entry of settings, the system will turn off the unit and cut off the gas supply. Before the battery in
the receiver is fully discharged, the controller will automatically shut off the gas supply o the stove.
Control
NOTE!!!
The remote control should always be kept out of the reach of children and other persons
unaware, not capable of assessing the consequences of their actions.
The user gets the device along with the included remote control, type B6R-H9 (Fig. 17).
Fig. 17. B6R-H9 remote control
55

Publicité

Table des Matières
loading

Table des Matières