Kratki PANTHER MERLOT Manuel D'utilisation Et D'installation page 53

Adjustment of the GV60 controller to supplies of various types of gas
The GV60 controller can be adapted so that it can work with specific ypes of gases. Gas pressure
control and minimum fl w are performed according to the instructions above.
Tightness test
After connecting the system to the gas network it is essential to check the tightness of the connec-
tions made with a special sensor. In the case of leaks, shut off the gas supply shu -off alve and repeat
the steps involved in installing various parts of the system.
Power supply connection
NOTE!!!
Connect the power supply only after connecting the combustion air system and any gas
control system components.
The B6R-R8U receiver is powered by four 1.5V AA batteries. Pay special attention to locate the wiring
connecting the gas control and the receiver away from hot parts of the stove. The need to replace the
batteries in the remote control is indicated by the indicator displayed in the upper right corner of the
display, while short beeps periodically appearing for three seconds immediately after starting the
fi ing process in the stove indicate the need to replace the batteries in the receiver. Used batteries
located in the receiver can overheat, spill or even explode. Do not use batteries that have been
exposed to the sun, moisture, heat or vibration. Install only batteries of the same type and the same
manufacturer. Do not install new batteries with worn ones. The kit can optionally include the G60-
ZB90 power module. This module is powered by four 1.5V AA batteries and should be connected
directly to the receiver in the place of the AC adapter connection. The additional power supply modu-
le eliminates the need for batteries in the receiver. Optionally, customers can buy a cable connecting
the interrupter block and the receiver for the gas control system, equipped with a switch. The switch
also protects the system against uncontrolled fl w of gas through the controller.
INSTALLATION OF THE OPTIONAL WI-FI MODULE
If you install the optional WI-FI module into the receiver, connect the AC adapter. The adapter is an
optional component and can be purchased from the manufacturer of the heater. The power supply
unit should be CE marked. Before connecting the power supply, make sure the battery in the control-
ler is removed. (See page 34.) The WI-FI module and power supply should be connected by qualified
personnel. Technical specific tion required for the power supply:
- Input voltage: 100-240V (50 / 60Hz)
- Current 0.2A
- Output voltage: 6VDC (1000mA)
- Connector 2.1x5.5 mm, polarization (+) inside (-) outside
Removing the glass
ATTENTION !!!
Removing the glass should only take place off cooled stove with gas supply off and disconnec-
ted power supply.
UThe device is equipped with a heat-resistant glass that withstands temperatures up to 800°C. To re-
place glass firs , remove the cover, the side grilles and unscrew the door as shown in Figures 9 and 10
and then remove the window by unscrewing the clamping plates mounted with (6 M5 screws).
53