Settings Via The Remote Control; Restart (Battery Version Only); Increasing/Decreasing The Flushing Duration Of The Main Flush - DURAVIT DuraSystem Série Notice D'utilisation

6.2 Settings via the remote control

Restart (battery version only)

You have a time frame of 3 minutes to enter function commands via the remote
control on the battery version of the actuator plate. You have 3 minutes from the last
time you pressed the button to make other settings. The remote control is deactivated
3 minutes after you last pressed the button to conserve the battery or actuator plate.
A restart must first be performed in order to make settings via the remote control at a
later time.
1

Increasing/decreasing the flushing duration of the main flush

You can increase or decrease the duration of the main flush by pressing the "Main
flushing time" button on the remote control (see table 1: Setting the main flush).
> Press the "+" setting button if you want to increase the flushing duration.
> Press the "-" setting button if you want to decrease the flushing duration.
The status LED flashes twice each time you press the button. The flushing duration is
increased/decreased by the corresponding steps.
The status LED flashes 5 times in succession if you have reached the maximum or
minimum range.
2
00:02:00
3
> Remove the actuator plate
(see 6.1 Removing the actuator plate).
> Remove the battery module from the
actuator plate.
> Wait at least 2 minutes.
> Connect the battery module to the
actuator plate.
> Remount the actuator plate
(see 6.1 Fixing the actuator plate).
The remote control is ready for use.
43