Pioneer PDP-S40 Mode D'emploi page 4

English
3. Fit the speaker to the mounting fittings in the correct direction.
• Be sure not to mount the speaker upside down.
For illustrative purposes,
the table top stand is not
presented here.
Caution
• To avoid any damage to the speaker and/or table top stand from striking against each other, fit the speaker to the mounting
fittings while confirming their locations. As you may easily strike the stand, use the protective wrapping in which the speaker
was wrapped between the speaker and stand.
• When the speaker mounting fittings do not fit the grooves at the rear of the speaker, adjust the speaker mounting fittings
angle.
4. Fix the speaker mounting fittings and the speaker with the supplied screws.
• Fix the center part of the speaker first with the supplied screws, then fix the right and left sides alike.
.
Screw hole
Speaker
mounting screw
(M5 x 10 mm)
Speaker
mounting screw
(M5 x 10 mm)
4
Insert the speaker
mounting fittings into the
grooves at the rear of
the speaker.
Screw hole
Speaker mounting screw
(M5 x 10 mm)
The bottom side of the speaker has a round corner
when viewed from the front side of the Plasma Display.
If you want to move the Plasma Display unit,
make sure that you remove the speaker first.
In addition, do not move the display holding on
to the mounting fittings. This can result in injury
or damage to the unit.
The screw hole at the bottom surface of the
speaker mounting fitting is used when the
Plasma Display is installed on the wall. It is
not used when installed with the stand.
Screw hole
If after attaching the speaker its position
needs to be adjusted horizontally or vertically,
first loosen the speaker mounting screws,
reposition and then tighten the screws again
at the appropriate position.
Protective
wrapping
Front side of
the speaker
The upper side of the speaker
does not have a round corner.
CAUTION
NOTE: