Maintenance - AEG Electrolux DL8560-M Mode D'emploi

EN

MAINTENANCE

The appliance can be controlled using a remote control powered by
a 1.5 V carbon-zinc alkaline batteries of the standard LR03-AAA
type (not included).
• Do not place the remote control near to heat sources.
• Used batteries must be disposed of in the proper manner.
CLEANING THE COMFORT PANELS
• Pull the Comfort Panel to open it.
• Disconnect the panel from the hood canopy by sliding the fi xing
pin lever.
• The comfort panel must never be washed in a dishwasher.
• Clean the outside by using a damp cloth and neutral liquid de-
tergent.
• Clean the inside as well by using a damp cloth and neutral de-
tergent; do not use wet cloths or sponges, or jets of water; do
not use abrasive substances.
• When the above operation has been completed, hook the panel
back to the hood canopy and close it by turning the knob in the
opposite direction.
CLEANING METAL SELF- SUPPORTING GREASE FILTERS
Alarm signal reset
• Switch off the lights and extractor motor.
• Press button T3 for at least 3 seconds, until the leds start to
fl ash.
Cleaning the fi lters
• The fi lters are washable and must be cleaned at least every 2
months of operation, or more frequently for particularly heavy
usage.
• Pull the Comfort Panel to open it.
• Remove the fi lters one at a time by pushing them towards the
back of the group and pulling down at the same time.
• Wash the fi lters, taking care not to bend them. Allow them to
dry before refi tting.
• When refi tting the fi lters, make sure that the handle is visible on
the outside.
REMOTE CONTROL
GREASE FILTERS
20