Overview Image; Using The Application Tool; Changing The Direction Of The Exchangeable Attachment; Changing The Position Of The Trigger - HellermannTyton HDT16 Manuel D'utilisation

5 Overview image

In Figure you can find an overview image of the application tool.
A
1 Exchangeable attachment
2 Cutting lever
3 Lever lock
4 Hanging loop for safety cord
5 Trigger
6 Tension element
7 Blade
Figure shows an overview image for the application.
B
1 LFPC profile
2 Cable tie head
3 Cable bundle
4 Strap end of the cable tie

6 Using the application tool

CAUTION
There is a risk of injury when actuating the trigger and tightening the cable tie, or when using unsuitable
cable ties.
f Always use safety glasses during work.
f When actuating the cutting lever, make sure that no limbs are between the cutting lever and the tool.
f Use only HellermannTyton stainless steel cable ties.
f If necessary, attach a spiral strap to the hanging loop of the rear trigger.

6 .1 Changing the direction of the exchangeable attachment

f Pull the exchangeable attachment
f Turn the exchangeable attachment
exchangeable attachment again.

6 .2 Changing the position of the trigger

The triggers (Figure
5 A
position for the user.
f Press in the lever lock
f Turn the rear trigger
(Figure
1 E
(Figure
1
) can be arranged in different positions to ensure an ergonomic working
(Figure ).
1 G
(Figure ) by up to 180° for two-hand operation.
1 H
Operating instructions • HDT16 • 02-2016 • 110-40000
) of the tool outwards.
) of the tool by 180° and then let go of the
F
Overview image
5