Table des Matières
Publicité
Preventing unnecessary recording (VAS)
When VAS (Voice Activated System) is set, if silence continues for approx. 2 seconds during
microphone recording, the recording is paused automatically. If the unit detects sound, the recording
resumes.
• Set the recording level adjustment to AUTO
beforehand. (➜ page 27)
• Press [STOP g/RETURN] to stop the unit.
1
Press [MENU].
2
Press +, – to select "MIC REC MENU"
and press [q OK] to enter.
3
Press +, – to select "VAS" and press
[q OK] to enter.
4
Press +, – to select "ON" and press [q OK]
to enter.
(The factory setting is "OFF".)
To exit the setting screen, press [F2 (CLOSE)].
*
When the recording level adjustment is MANUAL (➜ page 27), even if the VAS setting is set to ON, the setting
does not change to the VAS recording.
*
For important recording, set the VAS setting to OFF.
*
If the "LOW CUT FILTER" setting is "ON", low frequency sound may be cut out and VAS recording may not activate.
In this case, change the "LOW CUT FILTER" setting to "OFF". (➜ page 26)
*
If the recording is paused with no sound state, "
state, the status is changed to normal recording pause state and "
"
To start VAS recording, press [REC *].
Adjusting the VAS operation level:
Press u, i during VAS
recording.
(The factory setting is "3".)
*
You can adjust the sound detection level from 1 to 5.
*
If the audio to record is low, increase the VAS value
(sensitivity level). If the sound is loud, decrease the
VAS value.
" blinks. When [REC *] is pressed from this recording pause
" lights up.
" is displayed.
31
31
Publicité
Table des Matières
