Recommendations For Optimal Handling Of The Battery; Maintenance And Service; Maintenance And Cleaning - Bosch GBH Professional 36 V-LI Notice Originale

Inserting Screwdriver Bits (see figure N)
Apply the power tool to the screw/nut only
when it is switched off. Rotating tool inserts
can slip off.
To work with screwdriver bits, a universal bit
holder 31 with SDS-plus shank (accessory) is
required.
Clean the shank end of the adapter shank and
apply a light coat of grease.
Insert the universal bit holder with a turning
motion into the tool holder until it automatically
locks.
Check the locking effect by pulling the universal
bit holder.
Insert a screwdriver bit into the universal bit
holder. Use only screwdriver bits that match the
screw head.
To remove the universal bit holder, pull the lock-
ing sleeve 5 toward the rear and remove the uni-
versal bit holder 31 out of the tool holder.
Recommendations for Optimal Handling
of the Battery
Protect the battery against moisture and water.
Store the battery only within a temperature
range between 0 °C and 45 °C. As an example,
do not leave the battery in the car in summer.
Occasionally clean the battery venting slots us-
ing a soft, clean and dry brush.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
Bosch Power Tools

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool. Unintentional
actuation of the On/Off switch can lead to
injuries.
For safe and proper working, always keep
the power tool and the ventilation slots
clean.
A damaged dust protection cap should be
changed immediately. We recommend hav-
ing this carried out by an after-sales service.
Clean the tool holder 3 each time after using.
If the power tool should fail despite the care tak-
en in manufacturing and testing procedures, re-
pair should be carried out by an after-sales ser-
vice center for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit article num-
ber given on the type plate of the power tool.
After-sales service and customer
assistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer consultants answer your ques-
tions concerning best buy, application and ad-
justment of products and accessories.
In case of a claim, repair or purchase of replace-
ment parts or in case of queries or other prob-
lems, please contact your local dealer or Bosch
representative.
English | 15
1 619 929 779 | (22.8.07)