Audible Signals - Zanussi ZDT111 Notice D'utilisation

Wash indicator light
Saltindicator light
End of programmeindicator light

Audible signals

Audible signals have been introduced to help
indicate which operations the dishwasher is
performing.
– end of the washing programme,
– malfunction of the appliance
Factory setting: audible signals activated.
It is possible to deactivate the audible signals,
using the Programme selection/Cancel but-
ton.
Deactivation/activation of the audible sig-
nals
1. Press the On/Off button. The appliance
must be in setting mode.
2. Press and hold Programme selection/
Cancel button until programme light A
6
turns off and the End of programme light is flash-
ing.
3. Release the Programme selection/cancel but-
ton.
4. Switch off the machine by pressing the On-Off
button or select a new washing programme (check
that there is detergent in the detergent dispenser.
Indicator lights
Illuminates when the washing, rinsing and drying and
phases are running.
Illuminates when the special salt has run out.
Is never illuminated while a washing programme is
running.
Illuminates when the washing programme has ended.
It also has added functions of visual signalling as:
– the setting of the water softener,
– deactivation/activation of the audible signals,
– intervention of an alarm due to the malfunction of
the machine.
flashes and programme light B illuminates
with fixed light.
3. Press Programme selection/Cancel but-
ton again: programme light A becomes
fixed and programme light B starts flashing.
4. After a few seconds:
– programme light A turns off
– programme light B goes on flashing
– End of programme light illuminates
with fixed light, indicating that the audi-
ble signals are active.
5. To deactivate the audible signals press
again the Programme selection/Cancel
button: the End of programme light turns