Configuration Areas - E+E Elektronik HUMIPORT 05 IR Notice D'utilisation

Manual
6.2

Configuration areas

CFG: In the CFG mode the values for the
upper threshold (Hi) and the lower threshold
(Lo) are entered.
This menu item can only be selected if the DP
mode is active. The value range for Hi and Lo
is from 0.0 to 9.9. The units (°C or °F) are
taken from the temperature setting currently
selected for the DP mode.
The minimum difference between Hi and Lo must be 1.0.
The values for Hi (upper display) and Lo (lower display) are
entered and confirmed one after another.
Unit 1: You select the unit of temperature with Unit 1. °C and °F are
available for selection.
Selection can be made with
Unit 2: This menu item can only be selected if the TH mode is active.
With Unit 2 you select the unit of absolute humidity (g/m3), relative
humidity (% r.H.) or the dewpoint temperature (dp°C, dp°F). % r.H.
is set at the factory.
Selection can be made with
page 36
HUMIPORT 05 IR english
and , confirmation with
and , confirmation with
.
.