Operating Modes - E+E Elektronik HUMIPORT 05 IR Notice D'utilisation

Manual
6.1

Operating modes

TH: The instrument can be used as a
thermohygrometer when you select the
TH mode.
In this mode the temperature is shown in the upper display and the
humidity in the lower display.
The unit of temperature (°C, °F) is set in configuration area Unit 1
in this mode. °C is set at the factory. The units for humidity (% r.H.,
g/m3, dp °C, dp °F) are set in configuration area Unit 2. % r.h. is
set at the factory.
An offset correction of temperature and humidity values can be
made in the configuration areas CAL 1 and CAL 2.
The instrument has been designed exclusively for interior
pyrometric surface temperature measurements.
The surface temperature is indicated in the upper display in this mode.
The corresponding HOLD, MAX, MIN or AVG value is indicated in
the lower display if one of these functions was selected in the
upper menu.
page 32
HUMIPORT 05 IR english
IR: The instrument can be used as a
pyrometer when you select the IR mode.
In this mode you can measure the
temperature of surfaces without contact.