Display Description; Initial Use Of Parent Unit; Initial Use Of Camera; Initial Use Of Parent Unit With Battery - Beurer babycare BY 99 dual Mode D'emploi

6.3 Display description

1
2
3
4
2h
5
4h
1X
6h
2X

7. Initial use of parent unit

7.1 Initial use of camera

1. Place the camera on a level, firm surface and point the camera lens at the area that you wish
to monitor. Ensure that there are no other electrical devices in the proximity of the camera.
WARNING
Do NOT position the camera within reach of the baby!
2. Connect the small end of the "Baby" camera mains part plug to the camera.
3. Connect the other end of the mains part plug to the socket.
4. Move the ON/OFF switch to "ON" to switch on the camera. The function light on the cam-
era begins to glow blue.
5. Push the ON/OFF switch downwards to switch off the camera.

7.2 Initial use of parent unit with battery

emove
1. R the assembly clip.
2. Open the cover on the rear of the parent unit by sliding it downwards.
3. Insert the battery included in delivery as shown.
4. Slide the cover on the rear of the parent unit back up again, until you can hear and feel it
slot into place.
5. Snap the assembly clip into place once more.
1
1 *
2
*
3
4
5
15
C
60
F
Signal strength
Temperature display
Alarm clock
Infrared night vision
Lullaby
Intercom function
Alternating camera image
Camera number
Battery state
Energy-saving mode menu
Camera menu
Temperature menu
Alarm clock menu
Lullabies menu
Zoom menu
27