Care And Maintenance - SCHOLTES CI 66 M W S Mode D'emploi

Care and maintenance

Switching the appliance off
Disconnect your appliance from the electricity
supply before carrying out any work on it.
Cleaning the appliance
! Never use steam cleaners or pressure cleaners on
the appliance.
• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge which has been soaked in lukewarm
water and neutral soap. Use specialised products
for the removal of stubborn stains. After cleaning,
rinse well and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The hob grids, burner caps, flame spreader rings
and burners may be removed to make cleaning
easier; wash them in hot water and non-abrasive
detergent, making sure all burnt-on residue is
removed before drying them thoroughly.
• Clean the terminal part of the flame failure safety
devices* frequently.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product,
then dry thoroughly with a soft cloth. Do not use
rough abrasive material or sharp metal scrapers
as these could scratch the surface and cause the
glass to crack.
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.
• Do not close the cover when the burners are alight
or when they are still hot.
*
Only available in certain models.
Inspecting the oven seals
Check the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
Authorised After-sales Service Centre. We
recommend that the oven is not used until the seals
have been replaced.
Replacing the oven light bulb
Cavity
Light bulb
Seal
Cover
1. Remove the glass cover using a screwdriver.
2. Unscrew the light bulb and replace it with a
similar one: Wattage 15 W, cap E 14.
Replace the glass cover, making sure the seal is
positioned correctly ( see diagram ).
! Do not use the oven lamp as/for ambient lighting.
Gas tap maintenance
Over time, the valves may become jammed or
difficult to turn. If this occurs, the valve must be
replaced.
! This procedure must be performed by a
This procedure must be performed by a This procedure must be performed by a This procedure must be performed by a This procedure must be performed by a
qualified technician who has been authorised by qualified technician who has been authorised by qualified technician who has been authorised by qualified technician who has been authorised by qualified technician who has been authorised by
the manufacturer. the manufacturer. the manufacturer. the manufacturer. the manufacturer.
GB
To replace the
oven light bulb:
35