Yamaha AV-S77 Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 44
Readying the Remote Control
I Inserting the batteries
1
Remove the battery compartment cover.
2
Insert the two batteries (AA, R06, UM-3 type)
with + and – oriented properly.
3
Close the battery compartment cover.
Operational Area of the Remote Control
Front speaker unit
30°
AV-S77
+
h
h
+
g
g
h
q
w
g
s
a
d
w
t
y
e
r
Less than 6 m
30°
I Precautions regarding batteries
Misuse of batteries may result in leakage or bursting. Be
sure to follow the precautions given below.
• Insert batteries with (+) and (–) oriented according to the
marking in the battery compartment.
• Do not mix old and new batteries.
• Do not mix different types of batteries as they may offer
different voltage and performance even though they have
the same shape.
• Remove all batteries if they can no longer be used or if
the remote control is not going to be used for an
extended period.
• Do not use rechargeable batteries.
• If leakage occurs, wipe away all battery fluid inside the
compartment.
Preserving the manufacturer code
Replace batteries early before they become unusable.
The manufacturer code set by the user will be preserved
for about two minutes when batteries run out or when
they are removed. Note that the manufacturer code
setting may be lost if more than two minutes elapses.
Also, if you press any button on the remote control
accidentally while replacing batteries, the manufacturer
code will be lost.
I Battery replacement cycle
Replace all two batteries when the operational range of the
remote control starts to become shorter.
I Precautions on handling the
remote control
• The remote control may not be able to operate the front
speaker unit when an object blocks the remote control
sensor on the unit.
• Do not subject the remote control to impact. Do not
allow it to get wet or place it in a location subject to high
humidity.
• The remote control operations become difficult when
direct sunlight or other strong light (such as from an
inverter fluorescent lamp) strikes the sensor. Adjust the
relative positions of the light and the front speaker unit if
this happens.
• Remote control operations may not be possible if another
remote control is being operated at the same time.
GETTING STARTED
3
E-

Publicité

Table des Matières
loading

Table des Matières