Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating and control elements
Refrigerator compartment
7
Temperature display
8
Temperature setting buttons
On/Of button
9
bl
button (The
button
switches the refrigerator
compartment to maximum
cooling)
Switching the appliance on and off
You are recommended to clean the appliance before switching it
on for the first time (see „Cleaning").
Switching on: Press the ON / Off buttons (on left for refrigerator, on
right for freezer) so that the temperature display lights up/flashes.
Switching off: Press the On / Off buttons for approx. two seconds
so that the temperature display goes out.
Note
If the freezer compartment is switched off, the appliance is out
of operation.
Setting the temperature
To reduce the temperature
button (on left for refrigerator, on right for freezer).
Press the
To increase the temperature/warmer
button each.
Press the
- When pressing one of the buttons for the first time, the display
will start to flash.
- Pressing this button again enables you to change the temperature
setting.
- The electronic controls will switch over automatically about
5 seconds after the last time you pressed the button, and the
actual temperature will be displayed.
- You can change the temperatures
in the refrigerator between 9°C and 2°C
in the freezer between -16°C and -26°C.
Temperature display
In normal operation, the average refrigerator temperature
the warmest frozen food temperature
When starting up for the first time or when the appliance is warm,
dashes will appear until the temperature reaches a level that can
be displayed (19° to 0°C in the refrigerator and below 0°C in the
freezer).
If F1 to F5 appears in the display, the appliance has a fault. Con-
sult the customer serv ice department indicating the fault number
displayed.
28
Frezzer compartment
1
Temperature display
2
Temperature setting buttons
On/Of button
3
Superfrost-button
4
Audible warning On/Of button
5
Child lock is activated
6
3
2
7
will be displayed.
1
Audible warning signal
The appliance is equipped with an alarm function.
Audible/visual temperature alarm:
It sounds when it is not cold enough in the freezer compartment.
The temperature display will also flash;
The audible warning device is switched off by pressing the
The temperature display will continue to flash until the cause of
the alarm has been rectified.
This can be caused by:
• the freezer door being left open for a long time, allowing warm
ambient air to enter;
• a long power failure;
• a fault in the appliance.
In each case, make sure food has not defrosted or perished.
Additional functions
In set-up mode you can set the
child lock and adjust the bright-
ness of the display.
Activating set-up mode:
• Press the
button
button flashes.
- The
- The display shows c for child lock.
Note: The value to be altered flashes.
• Select the required function by pressing the
c = child lock,
h = display brightness or
• Now select/acknowledge the function by pressing the
briefly:
> For c = child-proof lock,
/
press the
button
c1 = child lock on or
c0 = child lock off and acknowledge with the
. When the symbol
ton
4
activated.
> For h = brightness,
/
press the
button
h1 = minimum to
h5 = maximum brightness and acknowledge with the
.
button
4
Exiting set-up mode:
• Exit the set-up mode by pressing the On/Off button
2 min. the electronic system switches over automatically. The
normal operating mode is activated again.
Power failure „frost-control" display
If nA appears in the display, this means that the freezer tempera-
ture has risen too high during the last few hours or days due to a
and
power failure.
If you press the „ALARM" button whilst the display is
reading nA, the highest temperature registered during
the power failure will be displayed. Check the quality
of the food and its suitability for consumption in case
it has become too warm or even defrosted.
The highest temperature will appear for appox. 1 minute. After that,
the actual temperature in the freezer will re-appear. The display
can be switched off by repeatedly pressing the „ALARM" button.
for approx. 5 seconds.
4
2
to select
is lit, the child lock is
2
to select
button.
/
button
2
:
button
but-
; after
3
Publicité
Table des Matières
