System Requirements; Declaration Of Conformity; Safety Regulations - Holmatro M 30 Série Mode D'emploi

1.5.2

System requirements

Because of the diversity of pump and tools not every industrial control valve can be connected to any
arbitrary pump or tool. In case of doubt about the compatibility of the system, always consult the
Holmatro dealer.
1.6 Qualified personnel
The system may only be operated by people trained in its use. Always obey local legislation, safety and
environmental regulations. Repair work may only be performed by a Holmatro Certified Technician.
1.7 Guarantee
Refer to the general terms and conditions of sale for the guarantee conditions, available from your
Holmatro dealer on request.
Holmatro draws your attention to the fact that every guarantee on your piece of equipment or system
will lapse and that you must indemnify Holmatro against any possible product liability and responsibility
if:
• service and maintenance are not carried out strictly in accordance with the instructions, repairs are
not performed by a Holmatro Certified Technician or are performed without prior written consent;
• self-made changes, structural changes, deactivation of safety devices, injudicious adjustment of
hydraulic valves and faulty repairs have been carried out;
• non-genuine Holmatro parts or hydraulic oils or lubricants other than the types prescribed are used;
• the piece of equipment or the system is used injudiciously, through errors of operation, improperly,
negligently or not in accordance with its nature and/or purpose.
1.8

Declaration of Conformity

Holmatro B.V. declares under its sole responsibility that this product 'M304, M311, M321-M325' is in
conformity with the standards and directives as described in section 3.3.
The original Declaration of Conformity is supplied with the applicable valve.
2

Safety regulations

2.1 Explanation of the symbols used in this manual
In this manual the symbols below are used to indicate possible dangers.
DANGER
Indicates an imminently hazardous situation which, if not avoided, will result in death or
serious injury.
WARNING
Indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not avoided, may result in minor or
moderate injury.
NOTICE
Is used to address practices not related to physical injury which, if not avoided, may result in
property damage.
M30* / M31* / M32* / VM43L 916.219.149_006
EN
23