Setup Within The Vehicle - Babyauto more KIDE 01 Manuel D'installation

Système de retenue pour enfant, groupe 0 et 1 de 0 à 18 kg (de 0 à 4 ans environ)
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

12. If you are in any doubt as to the use or installation
of the child seat, please contact our Customer
Services by calling +34 943 833 013.
13. Keep the safety seat away from corrosive
products.
14. The manufacturer guarantees the quality of
its products, but not the quality of second-
hand products or products belonging to other
companies.
3. INsTallaTIoN poINTs WITHIN THe VeHIcle
Facing the direction of travel
Facing away from the direction of travel
(Group 0 only)
With the 2-point belt (car seatbelt)
on seats with:
IsoFIX anchorage points (between the seat
and the seat back) and Top Tether anchorage
points (such as on the rear shelf, on the
ground or behind the seat) and 3-point
seatbelts in the vehicle (Group 0)
20
15. Instruction illustrations are for informational
purposes only. The child restraint system may
contain small differences compared to the
photographs or images in the instruction manual.
These variations do not affect its approval by ECE
Regulation R44/04.
Group 0
Group 1

4. seTUp WITHIN THe VeHIcle

Place the child seat in the rear of the vehicle, facing
away from the direction of travel (Group 0) or facing
forward (Group 1).
The child seat must be as closely attached to
the vehicle's seat as possible. For vehicles with
adjustable headrests, a better installation can be
achieved by adjusting the height or removing the
headrest (fig. 1) (Group 1).
It is important to replace the headrest in its position
when an adult is travelling.
The child seat must not be transported in the vehicle
without being buckled in, even when the child is
not travelling in the child seat. It is very important
to keep this in mind, in order to avoid any damage
that the child seat could cause in the event of an
accident. The child seat must therefore remain
installed at all times while driving.
Ensure that the distance between the child seat,
installed in the rear of the vehicle, and the front seats
is the maximum possible. (fig. 2).
fig. 1
fig. 2
21

Publicité

Table des Matières
loading

Table des Matières