AEG FAVORIT 88705 IM0P Notice D'utilisation page 11

You can set the released quantity of rinse
aid between level 1 (minimum quantity)
and level 6 (maximum quantity). Level 0
will deactivate the rinse aid dispenser
and no rinse aid will be released.
Factory setting: level 4.
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
,
flash and the display is blank.
2. Press Delay.
• The indicators
and go off.
• The indicator
flash.
• The display shows the current
setting: e.g.
– The levels of rinse aid are
from 0A to 6A.
– Level 0 = no rinse aid is
released.
3. Press Delay again and again to
change the setting.
4. Press the on/off button to confirm
the setting.
6.4 The rinse aid empty
notification
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If you are using multi-
tabs containing rinse aid and you are
satisfied with the drying result, you can
deactivate the notification for refilling
rinse aid. However, we recommend that
you always use rinse aid for best drying
performance.
If you use standard detergent or multi-
tablets without rinse aid, activate the
notification to keep the rinse aid refill
indicator active.
,
and start to
,
continues to
= level 4.
How to deactivate the rinse
aid dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
,
flash and the display is blank.
2. Press Start.
• The indicators
go off.
• The indicator
continues to flash.
• The display shows the current
setting: = the rinse aid
dispenser is activated (factory
setting).
3. Press Start to change the setting.
= the rinse aid dispenser is
deactivated.
4. Press the on/off button to confirm
the setting.
6.5 How to deactivate
AutoOpen
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and
Option until the indicators
,
flash and the display is blank.
2. Press Start.
• The indicators
and go off.
• The indicator
• The display shows the current
setting: = AutoOpen
activated.
3. Press Start to change the setting:
= AutoOpen deactivated.
4. Press the on/off button to confirm
the setting.
ENGLISH 11
,
and start to
, and
,
and start to
,
continues to flash.