Assembly - Husqvarna DM 540i Manuel D'utilisation

Masquer les pouces Voir aussi pour DM 540i:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Safety instructions for maintenance
WARNING:
instructions that follow before you do
maintenance on the product.
Remove the battery before you do maintenance,
other checks or assemble the product.
The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
Only use original spare parts.
Always use common sense
WARNING:
should you modify the original design of the
product without approval from the
manufacturer. Always use original spare
parts. Unauthorized modifications and/or
accessories may lead to serious injury or
death to the user or others.
WARNING:
as cutters, grinders, drills, that sand or form
material can generate dust and vapours
which may contain hazardous chemicals.
Check the nature of the material you intend
to process and use an appropriate breathing
mask.
It is not possible to cover every conceivable situation
you can face when using the product. Always exercise
Introduction
WARNING:
product, read the safety chapter.
14
Read the warning
Under no circumstances
The use of products such

Assembly

Before you assemble the
care and use your common sense. Avoid all situations
which you consider to be beyond your capability. If you
still feel uncertain about operating procedures after
reading these instructions, you should consult an expert
before continuing.
Do not hesitate to contact your HUSQVARNA
representative if you have any more questions about the
use of the product. We will willingly be of service and
provide you with advice as well as help you to use your
product both efficiently and safely.
Let your HUSQVARNA dealer check the product
regularly and make essential adjustments and repairs.
Husqvarna Construction Products has a policy of
continuous product development. HUSQVARNA
reserves the right to modify the design and appearance
of products without prior notice and without further
obligation introduce design modifications.
All information and all data in the operator's manual
were applicable at the time the operator's manual was
sent to print.
®
Bluetooth
CAUTION:
made to this equipment not expressly
approved by HUSQVARNA may void the
FCC authorization to operate this
equipment.
Notice: This device complies with Part 15 of FCC Rules
and with Industry Canada licence-exempt RSS
standard. Operation is subject to the following two
conditions:
This device may not cause harmful interference
This device must accept any interference received,
including interference that cause undesired
operation.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes:
l'appareil ne doit pas produire de brouillage, et
l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
WARNING:
during assembly, disconnect the battery
from the product.
Changes or modifications
To prevent accidental start
1567 - 001 - 21.06.2021

Publicité

Table des Matières
loading

Table des Matières