Husqvarna DM 540i Manuel D'utilisation page 16

3. Make sure that the green charging light on the
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
(Fig. 17)
4. When all LEDs on the battery come on, the battery is
fully charged. (Fig. 18)
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note:
Refer to the battery and battery charger
manuals for more information.
To use the auxiliary handle
(Fig. 19)
1. Turn the handle counterclockwise to release it.
2. Move the handle around the spindle shaft to an
applicable operation position.
3. Turn the handle clockwise to lock it. Tighten fully.
To use the product handheld
WARNING:
from a ladder. If the drill bit becomes
blocked, there is a high risk of fall injury.
(Fig. 20)
1. Always use a drill bit with a maximum diameter of 75
mm with handheld drill operation.
Operation
Handheld
Drill stand
WARNING:
blocked, a reaction will occur. Larger
diameter of the drill bit gives larger
reaction.
2. Lock the auxiliary handle tightly in position before
you operate the product. Refer to
auxiliary handle on page 16 .
To prepare the product for dry drilling
WARNING:
drill, which can cause injuries if breathed in.
Use approved breathing protection.
WARNING:
vacuum cleaner. Use only designated dust
extractors for hazardous dust. Refer to
16
Do not operate the product
Drill bit diameter, mm
25-75
25-100
If the drill bit becomes
To use the
Dust is made when you
Do not use a house-hold
Dust
extractor on page 23 for minimum
properties.
1. Attach the dust extractor connector to the mounting
thread on the product.
2. Attach the dust extractor to the dust extractor
connector. (Fig. 21)
3. Start the dust extractor.
To prepare the product for wet drilling
CAUTION:
maximum water pressure is not too high.
Technical data on page 21 .
Refer to
CAUTION:
prevent dirt blockage in the water system.
CAUTION:
supply coupling. Speak to your dealer for
more information.
1. Attach the water connector to the mounting thread
on the product. (Fig. 22)
2. Connect the Gardena
valve to the water connector. (Fig. 23)
3. Open the water system and adjust the water flow
with the valve. Set the water pressure to remove all
waste material from the drill hole. (Fig. 24)
To decrease the temperature of the
motor
• Operate the product with no load for 2 minutes to
decrease the temperature of the motor.
To change gear
CAUTION:
motor decreases in speed or stops. Do not
use force to change gear.
• Make sure that you always use the applicable speed
for the drill bit diameter. Refer to the rating plate on
Technical data on page 21 .
the product or
• Turn the gear selector to change gear. (Fig. 25)
To start the product
WARNING:
can rotate freely. It starts to rotate when you
push the power trigger.
1. Put the battery in the battery holder. (Fig. 26)
Make sure that the
Use only clean water to
Use only an approved water
®
male coupling with water
Change gear only when the
Make sure that the drill bit
1567 - 001 - 21.06.2021