Assembly; Installation - Husqvarna DMS 240 Manuel D'utilisation

• Do not use this tool for overhead drilling with water
supply. Water entering the power tool will increase
the risk of electric shock.
• When drilling overhead, always use the liquid
collection device specified in the instructions. Do not
allow water to flow into the tool. Water entering the
power tool will increase the risk of electric shock.
Safety instructions for maintenance
WARNING Inspection and/or maintenance
should be carried out with the motor
switched off and the plug disconnected.
Introduction
WARNING Read and understand the safety
chapter before you assemble the product.
WARNING To prevent injury, disconnect the
power cord and remove the drill bit before

assembly.

To attach the wheel kit
1. Attach the wheel kit on the rear side of the bottom
plate.
2. Tighten the screws.
Drill stand installation in operations
There are 2 methods that can be used to attach the drill
stand during a drill operation:
• With an expander bolt
• With a rod that has a thread, washer and locknut
898 - 002 - 20.06.2019
• Maintain power tools and accessories. Check for
misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the
power tool's operation. If damaged, have the power
tool repaired before use. Many accidents are caused
by poorly maintained power tools.
• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
• Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
Assembly
To attach the drill motor
1. Lock the drill motor carriage.
2. Attach the drill motor on the installation plate (A).
3. Attach the installation plate and drill motor in the
track (B) on the drill motor carriage.
4. Turn the screw (C) to lock the drill motor into
position.

Installation

A
B
C
31