Airwell IU-MINV-HW-9H Mode D'emploi page 26

Air Cleaning Filter
How to install the air
cleaning filter
NOTE
Cleaning the main unit and
remote control unit
Removing and remounting
the air intake grille
CAUTION
Washing the grille
with water
26
Care and Cleaning (continued)
The air cleaning filter removes dust and dirt from the air, and reduces
odors and smoke from tobacco.
This air cleaning filter cannot remove harmful gases or vapors nor
ventilate air in the room. You must open doors or windows frequently
when you use gas or oil heating appliances. Otherwise there is a risk of
suffocation in extreme cases.
The air cleaning filter needs to be installed behind the anti-mold filter.
1. Remove the anti-mold
filter.
2. Install the air cleaning
filter in the position
shown in the figure.
3. Reinstall the anti-mold
filter.
• In general, the filter should be replaced once every three months.
• Dirty air clean filters cannot be washed and reused. Purchase a
replacement filter at your local dealer.
• Wipe clean using a soft, dry cloth.
• To remove stubborn dirt, moisten a cloth in warm water no hotter
than 40 °C, wring thoroughly, and then wipe.
• The air intake grille can be removed in order to wash it with water.
• With the air intake grille open all the way, grip both arms with your
hands and pull toward you to remove.
To remount, hold the air intake grille roughly horizontal and push it in
until the arm shafts fit into the indentations in the main unit, then fit
the grille into place.
Air intake grille
When using a footstool or the like, be careful not to let it tip over.
• Clean the grille gently using a soft sponge, or the like. Then wipe
away any remaining moisture.
• Neutral detergent may be used to remove stubborn dirt. Then rinse
thoroughly with water and wipe away any remaining moisture.
Air
cleaning
filter
Arm
OI-757-26EG