Makita FN001G Manuel D'instruction page 7

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Depth of nailing can be adjusted by turning the adjuster
on the tool. A nail drives deeper as you turn the adjuster
in the A direction shown in the figure, and shallower in
the B direction, within a range of up to 2.5 mm (3/32").
B
► 1. Adjuster
1
► 1. Too deep 2. Right depth 3. Too shallow
Lighting up the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger or actuate the contact element
to light up the lamp. The lamp remains lit for up to 60
seconds while pulling the switch trigger or actuating
the contact element. The lamp goes out approximately
10 seconds after releasing the switch trigger and the
contact element.
1
► 1. Lamp
1
A
2
3
NOTICE:
Use a dry cloth to wipe the dirt off the lens
of the lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
NOTICE:
Even in the lamp lights up when the bat-
tery power residual gets small, nailer may not fire
nails. In this case, charge the battery cartridge.
NOTICE:
When the tool is overheated, the light
flashes. In this case, release the switch trigger and
contact element, and then cool down the tool/battery
before operating again.
NOTICE:
The lamp starts blinking if the nailer
detects an error during driving the nail. In this case,
bring the nailer to a Factory Service Center.
ASSEMBLY
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before carrying out any work on the
nailer.
Loading or unloading the nails
CAUTION:
Always make sure that your fin-
gers are not placed on the trigger and the battery
cartridge is removed before loading nails.
CAUTION:
Do not abruptly slide the slide
door of the nailer loaded with nails. Accidentally
dropping nails especially when working in high places
may cause personal injuries.
CAUTION:
Load nails in the correct direction.
Loading in wrong direction may cause premature
wear and tear of the driver and damage of the other
parts.
CAUTION:
Do not use deformed nail strips.
Use nails specified in this manual. Using nails other
than those specified may cause nail jamming and
breakage of the nailer.
1.
Press the lock lever and open the slide door of the
magazine.
► 1. Lock lever 2. Slide door 3. Magazine
7 ENGLISH
1
3
2

Publicité

Table des Matières
loading

Table des Matières