Safety Instructions - Trotec BE20 Manuel D'utilisation

Table of contents
Safety instructions . . . . . . . . . . . . . . . . . . . . . B - 1
Intended Use . . . . . .. . . . . . . . . . . . . . . . . . . . .B - 5
Appliance description . . . . . . . . . . . . . . . . . . .B - 6
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . B - 7
Technische Daten . . . . . . . . . . . . . . . . . . . . . . B - 11
This publication replaces all previous versions. No part of this publication may be
reproduced or processed, copied or distributed via electronic means in any form
whatsoever except with our written permission. We reserve the right to make tech-
nical changes. All rights are reserved. Trademarks are used in the following without
any guarantee of their free usability and are basically as the manufacturer descri-
bes them. The trademarks used are registered and should be treated as such. The
right to make design alterations in the interests of continuous product improvement
and alterations to the shape or colour is reserved. The package contents may differ
from the product illustrations. This document has been prepared with the approp-
riate care. Nevertheless, we can accept no liability for any errors or omissions. ©
TROTEC®
B - 1

01. Safety instructions

These instructions must be read carefully before put-
ting the appliance into operation or using it and must
always be kept near the place of installation or by the
appliance! The appliance was subjected to extensive
material, functional and quality checks before delivery.
This appliance can nevertheless represent a hazard if
it is not used for its intended purpose or if it is used
inappropriately by persons who have not been trained
to operate it.
In accordance with IEC – 61010, every appliance must
be marked with the following notice for protection
against overvoltage (transients) on the measuring con-
nections:
- Overvoltage category (CAT I, II, III, IV)
- Voltage range (300, 600, 1000 V)
Operating Manual – 2-pole Voltage Checker BE20
EN