Fault Finding Chart; Error Codes - BH FITNESS G-6446N Instructions De Montage Et Utilisation

FAULT FINDING CHART

PROBLEM
1. The monitor does not
switch on.
2. The monitor switches on
but the motor fails to
start.
3. Walking motion is jerky
on the treadmill.
4. The machine stops (the
breaker trips).
5. Electrical shocks
through the handrail.
6. The treadmill belt skews
off centre.

ERROR CODES

Monitor screen displays E1
Monitor screen displays E6-E7
Hesitate to get touch with us if you have any queries, by calling:
CHECKS
1) Make sure that the machine is
plugged in, the ON/OFF switch in
position 1 and that the safety key is
inserted.
2) Check that the current limiter is
pressed in.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on the
sliding belt.
3.c) Check the tension on the drive
belt.
4) Check that the band is lubricated. 4) Reset the overload button with
5) Check that the machine is
plugged into an earthed mains
socket.
6.a) Check that the machine is level
on the floor.
6.b) Check that the machine does
not wobble.
- Possible motor overload.
- Lubricate the belt.
- Elevation fault.
902 170 258
18
SOLUTIONS
1) Plug the machine into the mains
supply. Set the switch to position 1
and insert the safety key.
2) Switch the machine off and press
the circuit breaker in. Lubricate the
treadmill band.
3.a) Lubricate the sliding belt.
3.b) Adjust the belt tension.
3.c) Adjust the drive belt tension.
the On /Off switch at „0" and
lubricate the treadmill band.
5) Plug the machine into an earthed
mains socket.