Epson V12H949001 Instructions D'installation page 20

V12H949001 / AN3WA100
NOTE:
If a dial is making a clicking sound the circle outline
(NOT solid) will not move any further.
NOTE:
Ensure that shadows from your arm/body do not cover
the markers when making adjustments.
14. When the circles on the left and right become solid, press
the button on the remote control. The following
screen is displayed. (See Figure 43)
1
2
Figure 43
15. Place the markers at the top marker positions (1). When
angle adjustment is performed correctly, the upper circles
become solid. (See Figure 44)
1
2
Figure 44
NOTE:
If the upper circles become solid, proceed to Step 16.
If the upper circles do NOT become solid, perform the
following adjustment process:
20
•
IMPORTANT ! : If the circles do not become solid,
perform the following Steps a and b for slight adjustment.
a. Hold small level against face of sensor mount assembly
b. Adjust three screws on face of sensor mount assembly,
IMPORTANT ! : Once the face of the sensor mount
assembly is flush with the front of the screen bezel, turn
ALL of the three screws on face of sensor mount ONE
FULL TURN COUNTER-CLOCKWISE.
c. Return to Step 4 to begin the adjustment process again.
1
2
16. Place the markers at the bottom marker positions (2). When
angle adjustment is performed correctly, the bottom circles
become solid. (See Figure 46)
1
2
NOTE:
Installation Instructions
(OPTIONAL): Adjustment Process
(S) and screen. (See Figure 45)
as necessary, to ensure that the face of the sensor
mount assembly is flush with the front of the screen
bezel. (See Figure 45)
(S)
b
Figure 45
1
2
Figure 46
If the bottom circles do NOT become solid, perform the
(OPTIONAL) Adjustment Process (Steps a-c) shown
above.
Face of
screen
bezel
a
Level
1
2