Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Routing Cables
1.
Connect power cable, video cable, Touch Sensor cable and
Control Pad cables [2 USB and 1 remote cable {FF} (3.5mm
stereo mini jack)] following instructions included with the
projector. (See Figure 12)
Video cable
(HDMI, VGA,
etc.)
1
Touch
sensor
cable
Figure 12
2.
Use zip tie off points near the projector interface and on
projector mount. (See Figure 13)
3.
Route cables through boom arm. (See Figure 13)
4.
The control pad cables (2 USB and 1 remote cable) should
be laid on top of screen mounting bracket so that they can
be run down the side of the screen to the control pad. (See
Figure 13)
NOTE:
It will be helpful to hang cables over projector during the
screen installation.
Power
cable
Control pad
cables (2 USB)
Control pad cable
(Remote cable-
3.5mm stereo
Touch sensor
mini jack)
cable may
be bundled to
hang in place
V12H949001 / AN3WA100
Route cables
3
through boom arm
Remote cable
can be set
to right
side
(T)
Power cable may be
routed anywhere
around the screen,
or a recessed outlet
may be used
behind the screen.
Figure 13
2
Zip tie-off points
2 USB
cables
11
Publicité
Table des Matières
