Remote Functions; Remote Access - Abus Terxon Instructions D'installation

11.3 Remote functions

The remote access menu offers a wide range of applications through the
telephone line. These are described in more detail on the following pages.

11.3.1 Remote Access

Remote access can be started in two ways.
11.3.1.1 Remote access through dial-up
Using this function, you can access and configure the GSM dialer remotely.
The device can be operated either over an individual line or by sharing the line
with other devices.
Dial-up with "1 Ring Answer ON" function
3. Dial into the GSM dialer by entering the telephone number of the
device.
The device accepts the call after the defined number of rings (see
"Answer After").
4. Enter your four-digit remote code. A confirmation signal sounds when
the code is accepted. The remote access menu is now displayed. The
available functions are detailed on the following pages.
Dial-up with "1 Ring Answer OFF" function
5. Dial into the GSM dialer by entering the telephone number of the
device.
6. Let the device ring two or three times, then end the call.
7. Wait about 10 seconds, then dial into the GSM dialer again. The
device now accepts the call immediately and a selection of high-
pitched signal tones can be heard.
8. Enter your four-digit remote code. A confirmation signal sounds when
the code is accepted. The remote access menu is now displayed. The
available functions are detailed on the following pages.
11.3.1.2 Remote access over an alarm message
The GSM dialer starts a dialling procedure when the input is triggered. In this
case, the called contact can start the remote access mode after message
confirmation is made.
94